HANNA HI96769C Portable Anionic Detergents Photometer with 610-Nanometer Filter, Cal Check™ & Carrying Case, Range: 0.00 to 3.50ppm, Resolution: 0.01ppm

Detergents are produced in large quantities and are widely used in many applications. For example in the textile industry, paper mills, pharmaceuticals and cosmetics. Due to their common use, detergents are introduced into the water supply through domestic and industrial drains. Detergents are harmful to water treatment plants, due to the scum that is created by emulsifying oil and grease. So, by law, detergent concentrations must be monitored in wastewaters. HANNA® offers HI 96769C to monitor anionic detergents, expressed in sodium dodecylbenzene sulphonate, from 0.00 to 3.50 mg/L according to MBAS. HI 96706 is an auto-diagnostic portable photometer. The advanced optical system employs a specialized tungsten lamp and a narrow band interference filter, assuring accurate readings. This instrument is equipped with Cal Check® validation function and standards to validate good performance at any time. Taking just a few short steps, the validation procedure is user-friendly and ensures that the meter is properly calibrated wherever you go. Hanna photometers use the exclusive ready-made, NiST traceable standards to verify the performance of the instrument and recalibrate if necessary. Cuvets are constructed from specialized optical glass to ensure the best and most consistent results. The positive locking system ensures that the cuvet is in the same position every time it is placed into the measuring cell. Our sample cell is designed to fit a cuvet with a wide neck to make it easier to add both sample and reagents. All instruments are factory calibrated and the electronic and optical design minimizes the need for frequent calibration. Ideal for field applications, these meters are splash proof and the lamp and filter units are protected from dust or dirt by a transparent barrier. Display messages aid the user during routine operation. The auto-off feature will disengage the meter after 10 minutes of non-use in measuring mode or 1 hour while in calibration mode. Reagents are in powdered form and are supplied in packets. The amount of reagent is precisely dosed to ensure maximum repeatability. HI 96769C utilizes an adaptation of USEPA Method 425.1 for drinking waters, surface waters, domestic and industrial wastes and Standard methods, 20th Edition, 5540C, Anionic Surfactants as MBAS. Hanna #: HI 96769C. Range: 0.00 to 3.5 mg/LResolution: 0.01 mg/LAccuracy: ±0.04 mgL to 1.00 mg/LLight Source: Tungsten lamp with narrow band interface filter 610 nm.Light Life: Life of the instrument Light Detection: Silicon Photocell Battery Type / Life: 1 x 9V / approx. 40 hours of continuous use; auto-off after 10 minutes of non use Environment: 0 to 50°C (32 to 122°F); RH max 95% non-condensing Dimensions: 180 x 83 x 46 mm (7.1 x 3.3 x 1.8") Weight: 290 g (10 oz.) Method: Adaptation of the USEPA method 425.1 for drinking waters, surface waters, domestic and industrial wastes and Standard Methods, 20th edition, 5540C, Anionic Surfactants as MBAS. HI 96769C is supplied with CAL CHECK™ standard cuvets, (2) sample cuvets with caps, (1) long glass vial (25 mL) with cap, (3) plastic pipettes, 9V battery, tissue for wiping cuvets and instruction manual in a hard carrying case.

Detergents are produced in large quantities and are widely used in many applications. For example in the textile industry, paper mills, pharmaceuticals and cosmetics. Due to their common use, detergents are introduced into the water supply through domestic and industrial drains. Detergents are harmful to water treatment plants, due to the scum that is created by emulsifying oil and grease. So, by law, detergent concentrations must be monitored in wastewaters. HANNA® offers HI 96769C to monitor anionic detergents, expressed in sodium dodecylbenzene sulphonate, from 0.00 to 3.50 mg/L according to MBAS. HI 96706 is an auto-diagnostic portable photometer. The advanced optical system employs a specialized tungsten lamp and a narrow band interference filter, assuring accurate readings. This instrument is equipped with Cal Check® validation function and standards to validate good performance at any time. Taking just a few short steps, the validation procedure is user-friendly and ensures that the meter is properly calibrated wherever you go. Hanna photometers use the exclusive ready-made, NiST traceable standards to verify the performance of the instrument and recalibrate if necessary. Cuvets are constructed from specialized optical glass to ensure the best and most consistent results. The positive locking system ensures that the cuvet is in the same position every time it is placed into the measuring cell. Our sample cell is designed to fit a cuvet with a wide neck to make it easier to add both sample and reagents. All instruments are factory calibrated and the electronic and optical design minimizes the need for frequent calibration. Ideal for field applications, these meters are splash proof and the lamp and filter units are protected from dust or dirt by a transparent barrier. Display messages aid the user during routine operation. The auto-off feature will disengage the meter after 10 minutes of non-use in measuring mode or 1 hour while in calibration mode. Reagents are in powdered form and are supplied in packets. The amount of reagent is precisely dosed to ensure maximum repeatability. HI 96769C utilizes an adaptation of USEPA Method 425.1 for drinking waters, surface waters, domestic and industrial wastes and Standard methods, 20th Edition, 5540C, Anionic Surfactants as MBAS. Hanna #: HI 96769C. Range: 0.00 to 3.5 mg/LResolution: 0.01 mg/LAccuracy: ±0.04 mgL to 1.00 mg/LLight Source: Tungsten lamp with narrow band interface filter 610 nm.Light Life: Life of the instrument Light Detection: Silicon Photocell Battery Type / Life: 1 x 9V / approx. 40 hours of continuous use; auto-off after 10 minutes of non use Environment: 0 to 50°C (32 to 122°F); RH max 95% non-condensing Dimensions: 180 x 83 x 46 mm (7.1 x 3.3 x 1.8") Weight: 290 g (10 oz.) Method: Adaptation of the USEPA method 425.1 for drinking waters, surface waters, domestic and industrial wastes and Standard Methods, 20th edition, 5540C, Anionic Surfactants as MBAS. HI 96769C is supplied with CAL CHECK™ standard cuvets, (2) sample cuvets with caps, (1) long glass vial (25 mL) with cap, (3) plastic pipettes, 9V battery, tissue for wiping cuvets and instruction manual in a hard carrying case.