DRIERITE® 26800-EA Laboratory Gas Drying Unit with Hose Barbs, Filled with 8-Mesh Indicating DRIERITE®
- Dries both air and gases saturated with moisture to a dew point level of approximately –73°C (–100°F)
- Includes ~567g (1.25-Lbs of 8-Mesh Indicating Drierite® desiccant.
- Hose Barb Fittings: Accepts 1/4- to 3/8-Inch Tubing
- O.D. x Height 2.62 x 11.38-Inches. Molded polycarbonate column with stainless-steel desicant supports and coil spring.
- Recommended Flow Rate: 200L/Hour or 0.1 scfm for Maximum Efficiency; Pressure Drop: <0.01 psi at 200 lph; Water Capacity: 50g.
- Sold Individually
- Manufacturer Part No: 26800-EA
PLEASE NOTE: Product images and descriptions may not exactly represent the product. Prior to making your purchase, please confirm that the manufacturer part number shown above matches the product you seek. Returns are not allowed for such differences if the correct manufacturer part number is shipped.
Details
W.A. Hammond Drierite® gas drying units dry both air and gases saturated with moisture to very low dew point levels. These gas drying units are filled with approximately 567g of Drierite® 8-mesh indicating desiccant. Indicating desiccant can be easily regenerated by heating the desiccant on a tray at at 210 to 220°C for 1 hour in a single layer. Once exhausted, the same desiccant can easily be replaced with a fresh batch of indicating desiccant. Use in virtually any air or gas application which includes sample prep, blanketing, protection of lab instruments & equipment, gas purging, vacuum release, reaction mixtures or dry air venting.
Drierite® indicating desiccant provides visual proof by means of color change that the desiccant is absorbing moisture. The desiccant is a blue color when active and a pink color when exhausted. The zone between the two colors in the column may be a purple color and should be a sharp narrow band when the flow rate is at equilibrium. Regeneration by re-heating the desiccant will restore the drying capacity and the color back from pink to blue when fully dried.
Documents & Videos
W.A. Hammond Drierite® gas drying units dry both air and gases saturated with moisture to very low dew point levels. These gas drying units are filled with approximately 567g of Drierite® 8-mesh indicating desiccant. Indicating desiccant can be easily regenerated by heating the desiccant on a tray at at 210 to 220°C for 1 hour in a single layer. Once exhausted, the same desiccant can easily be replaced with a fresh batch of indicating desiccant. Use in virtually any air or gas application which includes sample prep, blanketing, protection of lab instruments & equipment, gas purging, vacuum release, reaction mixtures or dry air venting.
Drierite® indicating desiccant provides visual proof by means of color change that the desiccant is absorbing moisture. The desiccant is a blue color when active and a pink color when exhausted. The zone between the two colors in the column may be a purple color and should be a sharp narrow band when the flow rate is at equilibrium. Regeneration by re-heating the desiccant will restore the drying capacity and the color back from pink to blue when fully dried.